Using the Burn card maker you can write your image to a micro sd card and following any of the methods above will yield you a proper flash. I have not used this method as it shows very little success for my devices. On this device with a newer chip there are pads on the opposite side of the board right under the NAND itself. Check pins for other devices online first.

You should choose 6-7 or 7-8 pin from NAND bottom on the right side or 6-7 or 7-8 pin from first pin (first pin is marked on PCBA with a triangle) Short circuit it while plugging to Host PC and powering on.Place PCB in front of you so you can clearly read NAND’s name and board number.In some boxes you also need detached heatsink or cooler in order to reach NAND Open device housing and find the NAND.You can also checkout the source document which contains source images I posted here. You will need to have the USB Burn tool installed and follow the steps from method 2. This is also called MaskRom mode on many devices including Rockchip devices. Take a look at the image below for some examples. Shorting the NAND chip’s two pins will throw the device into flash mode on some devices.

Most new devices uses pads for this while older devices have exposed leads on the old memory chips. This is is risky and very diffucult to spot and document as each device is different. You can also hold the reset button if it does not. Go to File -> import image, Select your image, Hit Start, and finally plugin your device. You can also try product pages ussually seem to post download links. Image Source Recover method 2: AMLogic Burn toolįind a downloadable image for your specific device out in the wild. You have to hold it down for about 3-4 seconds to trigger recovery. Try it first while its unplugged so you can get the hang of it and not short anything out internally live. Feel free to shove a paperclip carefully to not miss the button and hit a component. However some may not know that the reset button has dual purpose and is also hidden cleverly behind the “AV” or “IR” port on some of these boxes. Yes I know, very basic and im sure most of you have tried it. This document does NOT contain any proprietary knowledge that wasnt already sourced from the internet. If you want original links please ask me if I havent already posted them in one of the Image Source links. I will start off with the basics and work my way up to the more advanced methods.Įverything in this document was sourced from somewhere online. In reality it is really difficult to fully brick one of these units permanently. I will talk about which I have used and others. Theres a few ways on the amlogic chips to recover boxes, but theres also many ways to recover these units.

Usb burning tool 2.1 7.3 download